Zimmerit Coating Sheet for 1/35 Scale Elefant
Tamiya
Tamiya | 货号： 12644 | 1:35
基本信息
- 品牌:
- Tamiya
- 标题:
- Zimmerit Coating Sheet for 1/35 Scale Elefant Tamiya
- 数量:
- 12644
- 比例:
- 1:35
- 类型:
- 细节改造件
- 发布:
- 2012
- 条码:
- 4950344126446 (EAN)
- 包装:
- 袋装
- 主题:
- Sd.Kfz. 184 Ferdinand » 坦克歼击车 (车辆)
开盒详情
包装尺寸:
330x135x1 mm
(13x5.3x0 inch)
重量:
20 g (0.04 lbs)
设计为
该改件适用于：:
Tamiya
2012
新模具说明书
下载 2605Kb (.pdf)
市场
No partner shops available
开盒测评
外部链接评测
广告
评测
AMPS
评测
IPMS-USA
评论
Jens AndréeI have mixed feelings about this zimmerit sheet. The quality was great! No doubt about it - BUT there's no excuse to not cutting the pieces with a laser cutter or knife plotter my Tamiya. Cutting out the pieces wasn't too hard, but all the little holes that needed cutting was a different story... I eventually resorted to using small PCB drills to cut the holes needed, but perfect it wasn't and unless Tamiya starts to pre-cut the individual pieces I won't do another zimmerit sheet. Just my opinion.
4 July 2017, 01:13
Holger KranichHi Jens,
i have this sheet too and i am not very amused, too. And i experienced that in corners or edges the glue dont stick enough. And for the holes, you have to take a punch and die set.
BTW welcome to scalemates!
Cheers Holger
4 July 2017, 06:35
Jens Andrée 作者I badly wanted a punch set when I discovered that you had to cut all those holes in the sheet, but they are sadly missing from my otherwise extensive "toolbox", but brand new PCB drills did the trick - but it was slow and required more than a few breaks in order to "cool down"...
I've been lucky so far with my zimmerit still sticking well to the model, but I made sure not to touch the sticky side prior to placing them and I hope it'll work in the long run? I'd be a bit upset if they start to peel off in a year or so... Regardless, unless Tamiya pre-cuts these zimmerit sheets I won't ever use them again. Not fully thought through if you ask me - but they look fantastic when done!
Thanks for you kind comment!
4 July 2017, 20:25
项目
参考资料
