Grumman F6F-5K/3K Drone Groupbuild
1
October 12, 20162
November 11, 2016Pattern for holes for ignition wires in the ignition ring (of 0,8x0,8 mm squere rod).3
November 12, 2016It was worthy to use the ANT-parts: looks OK and save a lot of time4
November 12, 2016For comparison: Eduards R-28005
November 12, 2016A little bit detailing on the inner side of the cowl + thinned edges in the area the cowl-flaps.6
November 13, 20167
November 13, 20168
November 14, 20169
November 14, 201610
November 15, 2016Hinges as usual in last time made of pins of an electric connecting block.11
November 15, 2016Trailing edge of the fixed surfaces is not inline. In contrast to that the trailing edge of both elevators is inline. It is correct: Eduard done a good work!12
November 18, 201613
November 18, 201614
November 21, 201615
November 24, 201616
December 1, 201617
December 1, 201618
December 1, 201619
December 4, 201620
December 4, 201621
December 4, 201622
December 4, 201623
December 4, 201624
December 7, 201625
December 7, 201626
December 7, 201627
December 8, 201628
December 8, 201629
December 10, 2016New pictures with reduced saturation for preventing candy-look.30
December 10, 201631
December 10, 201632
October 12, 201633
December 10, 201634
December 10, 201635
December 10, 201636
January 9, 2017Result of the group build: left is Hanno Kleinecke -3K37
January 9, 201738
December 10, 201639
December 10, 201640
October 12, 201641
December 1, 201642
December 10, 201643
December 10, 201644
December 10, 201645
December 10, 201646
December 10, 201647
December 10, 201648
December 20, 2016Reworked antenna configuration: double wire.49
December 20, 2016
Коментарі
9 September 2024, 00:13 -