Hasegawa A-6E Intruder low viz

1
July 25, 2017
starboard wing assembled
2
September 12, 2017
fuselage closed up
3
September 12, 2017
port wing attached to the fuselage
4
September 12, 2017
starboard wing and horizontal stabilizer attached
5
September 12, 2017
radome, exhaust nozzles, and speed brakes assembled
6
September 13, 2017
intakes added
7
September 24, 2017
top fuselage seam filled and primed
8
October 2, 2017
bottom fuselage seam work
9
October 13, 2017
main areas painted
10
October 20, 2017
working on the canopy
11
October 21, 2017
12
October 25, 2017
glosscote applied
13
November 25, 2017
first decals
14
November 25, 2017
some left side decals
15
December 24, 2017
canopy finally fixed and refuelling probe on
16
December 24, 2017
more decals
17
November 17, 2018
18
November 17, 2018
19
November 17, 2018
20
November 17, 2018
21
November 17, 2018

Коментари

25 July 2017, 02:39

Ekki
Watching.

12 September 2017, 17:20

Kerry COX
Lots of 'control' there. 🙂 I'm watching too. 🙂

13 September 2017, 04:20

Holger Kranich
Oh an A-6, i´m in here, Ed!

13 September 2017, 06:41

Ed Hubbart
Thanks all. The pictures don't show it, but I actually had to relocate the port wing slightly. When I went to install the exhaust Monday night, it wasn't sitting flush, so I had to remove the wing, put the exhaust piece in where it went, and then reglue the wing in the proper alignment.

13 September 2017, 13:49

Holger Kranich
What markings will you give her? Desert Storm?
I guess it was not easy to remove the wing, hu?

13 September 2017, 13:54

Kerry COX
Ed, are you guilty of Not following the instructions Eh.? Mmmmmmmmm

13 September 2017, 13:54

Holger Kranich
Oh i did this kit, too! Years ago from a Revell boxing! LOL 😄

13 September 2017, 13:57

Ed Hubbart
Actually, the wing came out pretty easily. I was surprised.

13 September 2017, 14:01