1930 Bentley 4.5 Litre Supercharged
Комментарии
54 24 October 2023, 17:28
Villiers de Vos
My oldest shelf queen. She has been languishing for nearly 30 years. She has survived South Africa's heat and two address changes. I hope that all the parts are still here, as well as being able to do justice to this gem.
My oldest shelf queen. She has been languishing for nearly 30 years. She has survived South Africa's heat and two address changes. I hope that all the parts are still here, as well as being able to do justice to this gem.
24 October 2023, 17:33
Villiers de Vos
The partially assembled engine block and supercharger was found. Using bleach I am stripping the paint before detailing and priming the sub-assemblies. So far so good.
The partially assembled engine block and supercharger was found. Using bleach I am stripping the paint before detailing and priming the sub-assemblies. So far so good.
27 October 2023, 06:38
Villiers de Vos
Gorby: You are welcome.
Yeon Sung Jung: 이 모델을 제작하는 것이 좋습니다. 또한 1975년에 생산된 이 모델을 손에 넣을 수 있었던 것은 매우 행운이었습니다.
This project was started before the introduction of Tamiya Extra Thin Cement. I seem to have used a combination of Tamiya Cement and Super glue. I have been busy checking what is in the box and assess what I have done. I cleaned the parts from dust, assessed damage, paint parts with a primer, removing chrome, fill ejector pin marks, do some repair work and try to determine if there are parts lost. So far, the only part missing is the backing for the back seat. There has also been close to no damage.
This kit is part of the Connoisseurs' Series, which mean that the kit has the potential to be motorised. The kit comes with two sets of instructions: 1) One set for the Connoisseurs' Series, and 2) The standard kit. The only difference that I could identify is that the Connoisseurs allows for inserting gears to accommodate an electric motor. I will not be installing a motor nor the gears.
Fortunately, there are many reference photographs. I do not plan to do a lot of scratch building. What my skills allow and to enhance the exterior of the model. My research indicate that the coachwork/ body was a wood frame covered in green leather.
My plan is to: 1) Start with the chassis, including painting and detailed painting; 2) Engine, drivetrain; 3) Fuel tank and exhaust; 4) Body, firewall, interior; 5) Nose; 6) Wheels.
Gorby: You are welcome.
Yeon Sung Jung: 이 모델을 제작하는 것이 좋습니다. 또한 1975년에 생산된 이 모델을 손에 넣을 수 있었던 것은 매우 행운이었습니다.
This project was started before the introduction of Tamiya Extra Thin Cement. I seem to have used a combination of Tamiya Cement and Super glue. I have been busy checking what is in the box and assess what I have done. I cleaned the parts from dust, assessed damage, paint parts with a primer, removing chrome, fill ejector pin marks, do some repair work and try to determine if there are parts lost. So far, the only part missing is the backing for the back seat. There has also been close to no damage.
This kit is part of the Connoisseurs' Series, which mean that the kit has the potential to be motorised. The kit comes with two sets of instructions: 1) One set for the Connoisseurs' Series, and 2) The standard kit. The only difference that I could identify is that the Connoisseurs allows for inserting gears to accommodate an electric motor. I will not be installing a motor nor the gears.
Fortunately, there are many reference photographs. I do not plan to do a lot of scratch building. What my skills allow and to enhance the exterior of the model. My research indicate that the coachwork/ body was a wood frame covered in green leather.
My plan is to: 1) Start with the chassis, including painting and detailed painting; 2) Engine, drivetrain; 3) Fuel tank and exhaust; 4) Body, firewall, interior; 5) Nose; 6) Wheels.
14 November 2023, 21:34
Villiers de Vos
Thank you Yeon Sung Jung for the compliment.
The search for an accurate colour match is under way. Two objectives: 1) A highly gloss for the chassis, mudguards and fuel tank, and; 2) A similar colour that will show minuscule differences between the metal surface and the leather surface.
Thank you Yeon Sung Jung for the compliment.
The search for an accurate colour match is under way. Two objectives: 1) A highly gloss for the chassis, mudguards and fuel tank, and; 2) A similar colour that will show minuscule differences between the metal surface and the leather surface.
16 November 2023, 14:02
Villiers de Vos
You are welcome David.
Humbrol 003 Brunswick Green represents the real colour best. I am very satisfied how the Humbrol paints are laying down.
You are welcome David.
Humbrol 003 Brunswick Green represents the real colour best. I am very satisfied how the Humbrol paints are laying down.
16 November 2023, 17:26
Isaac Kite
Yea, folks knock humbrol enamels (rightly so for the pricing) but just spend three minutes mixing the stuff and do it well. Some of my 1990s batch are still very good when thoroughly stirred up. (WEM also). Still dislike acrylics.
Watching as usual with awe...
Yea, folks knock humbrol enamels (rightly so for the pricing) but just spend three minutes mixing the stuff and do it well. Some of my 1990s batch are still very good when thoroughly stirred up. (WEM also). Still dislike acrylics.
Watching as usual with awe...
20 November 2023, 16:55
Villiers de Vos
Thank you mates for visiting and your kind comments.
I am not an expert on paint. I use a variety of manufacturers and is very much still in the experimental phase. That being said, there is a lot of nostalgia in using the little tins on a British classic. 🙂
Thank you mates for visiting and your kind comments.
I am not an expert on paint. I use a variety of manufacturers and is very much still in the experimental phase. That being said, there is a lot of nostalgia in using the little tins on a British classic. 🙂
28 November 2023, 06:06
Villiers de Vos
A lot of time was spent on finding the desired colours, contemplating levels of detailing and stripping back paint just to be painted again. Despite the kit's age and shortcomings, I thoroughly enjoy the model.
A lot of time was spent on finding the desired colours, contemplating levels of detailing and stripping back paint just to be painted again. Despite the kit's age and shortcomings, I thoroughly enjoy the model.
7 December 2023, 04:06
Rando
Definitely enjoying your paint selection process, and very cool that you're getting around to building it after so many years. Excited to see how it turns out!
Definitely enjoying your paint selection process, and very cool that you're getting around to building it after so many years. Excited to see how it turns out!
7 December 2023, 04:36
David Taylor
Die hard Humbrol and hairy stick guy.This kit has always been a curiosity to me.Always fancied having a go but knowing I would not do it justice.
Die hard Humbrol and hairy stick guy.This kit has always been a curiosity to me.Always fancied having a go but knowing I would not do it justice.
8 December 2023, 22:30
Villiers de Vos
Progress on the drivetrain was made.
David. Thank you for your kind words. I am sure you will do it justice.
Progress on the drivetrain was made.
David. Thank you for your kind words. I am sure you will do it justice.
14 December 2023, 20:54
Michael Kohl
Unreachable dream kit of my early youth. Special to see it coming together. Keep us posted.
Unreachable dream kit of my early youth. Special to see it coming together. Keep us posted.
14 December 2023, 21:47
Villiers de Vos
Michael. I am also happy to eventually working on the Bentley. It has been 30 years languishing in an open box. 🙂
Michael. I am also happy to eventually working on the Bentley. It has been 30 years languishing in an open box. 🙂
15 December 2023, 07:49
Chris
As a child, about 45 years ago, I built that big Bentley, but after 4 times changing the houses it is gone. Luckily I found my tiny little 1:32 Bentley I built this year after 23 years of absence. But now I will lean back and enjoy the building of the/your big Bentley while watching your work 😄 Thanks
Btw.: All that is left from my childhood is the instruction book.
As a child, about 45 years ago, I built that big Bentley, but after 4 times changing the houses it is gone. Luckily I found my tiny little 1:32 Bentley I built this year after 23 years of absence. But now I will lean back and enjoy the building of the/your big Bentley while watching your work 😄 Thanks
Btw.: All that is left from my childhood is the instruction book.
18 December 2023, 00:18
Villiers de Vos
Chris, Jorge and Casey, welcome aboard. The project will pick up pace as soon as the fuel tank has been completed.
I am wishing to each and everyone all the best for 2024.
Chris, Jorge and Casey, welcome aboard. The project will pick up pace as soon as the fuel tank has been completed.
I am wishing to each and everyone all the best for 2024.
31 December 2023, 19:52
David Goodchild
This really looks excellent, and it's more impressive having sat unfinished in the box for so long! Very much looking forward to seeing the end result...
This really looks excellent, and it's more impressive having sat unfinished in the box for so long! Very much looking forward to seeing the end result...
11 January, 21:31
CaptGPF
Love how you step us through your method of madness in restoring the details! Looking forward to seeing this gem all done up after the long wait on the shelf! 😀
Love how you step us through your method of madness in restoring the details! Looking forward to seeing this gem all done up after the long wait on the shelf! 😀
19 February, 15:41
Mick Burdett
Good work V. I believe it was the first British car to be built using metric measurements, but I could be wrong
Good work V. I believe it was the first British car to be built using metric measurements, but I could be wrong
4 March, 21:19
David Orr
Love the old Airfix Bentley. I built my father's kit last year after it had languished in a closet for nearly 50 years. Unfortunately the tyres had been left loos in the box and melted a few parts, mainly on the engine valve cover and the gearbox, but I was able to rebuild them. I used SMS British Racing Green for the shiny parts of the body. I think it looks similar to the colour you used. I used BRG mixed with Schwarzgrun and a bit of white for the passenger compartment and a BRG/white mix for the leather. You are a braver man than me stripping all that detail off the fuel tank. It's looking good though.
Love the old Airfix Bentley. I built my father's kit last year after it had languished in a closet for nearly 50 years. Unfortunately the tyres had been left loos in the box and melted a few parts, mainly on the engine valve cover and the gearbox, but I was able to rebuild them. I used SMS British Racing Green for the shiny parts of the body. I think it looks similar to the colour you used. I used BRG mixed with Schwarzgrun and a bit of white for the passenger compartment and a BRG/white mix for the leather. You are a braver man than me stripping all that detail off the fuel tank. It's looking good though.
9 May, 01:07