Q-2A Firebee
Comments
14 25 October 2021, 17:55
Roland SachsenhoferI'm taking the liberty of getting off to a flying start here, so to speak, and I'm getting in just before the end of this small but fine project. So far, everything has been "off the shelf", but now I'm going to do a bit of rebuilding: the suspension on the transport frame has been oversimplified by ICM, so I'll try to improve it a bit with scratched parts. But one thing is already certain: this is a really well-made kit for in-between!
25 October 2021, 18:01
Roland SachsenhoferThis wonderful little ICM-kit is finished. A few improvements have been made to the suspension of the drone in the trolley: I have replaced the central flange with a metal rod and added the two side stabilisers. This was done with some plastic and fine wire pins from the scrap box. The fine holes for these scratched parts were the only challenge in this relaxing construction.
Who knows? Maybe ICMs fabolous A-26 as a mothership will follow.... 🙂
29 October 2021, 06:48
Roland SachsenhoferBy the way: I have unravelled the mystery of the meaning of "I go Pogo"! If there is interest, I can gladly post the riddle here.
29 October 2021, 06:50
