SB-17G ARS

Roland Sachsenhofer
First pictures of the first steps in the construction of a B-17G, whose mission role particularly appealed to me: I had long been fascinated by the sea rescue missions of this B-17 equipped with a droppable lifeboat! So I was delighted when I found one of the rare kits on the subject here on scalemates.
A few months ago I had already built an Academy 'Flying Fortress' in an early B version, the kit qualities of which I thoroughly enjoyed. The accuracy of fit is not far from 'perfect' and the details that are often missing in these Academy kits have to be added wherever it is important. In this case that means A set of etched parts for the cockpit and nose area, as well as an exterior set, especially for the engines and undercarriage, and resin tyres, also from Eduard. Not to forget: the seat cushions from Kits World were used in the cockpit

Łukasz Gliński
Lucky you! Following

Finn
I'm in

Roland Sachsenhofer
That makes me happy, Łukasz and Finn!
The SB-17G is slowly taking shape. The V-position of the wings needs to be changed: in my opinion, Academy has set a much too steep angle here! The corrected position of the wings also results in the distances at the wing-fuselage bonding points.... the fit here would be excellent!

Juergen Klinglhuber
following 👍

Roland Sachsenhofer
Das freut mich! 🙂

Roland Sachsenhofer
In preparation for the surface colours, I have now done the following: I have masked those stripes over the black primer that are to remain visible as black lines separating the NMF surfaces from the large yellow zones using suitably wide Tamiya masking tape. I also masked the areas on the leading edges that carry the rubber 'de-icers'.
Next, the anti-glare areas in front of the cockpit and on the inside of the engine nacelles are sprayed, then.... then come the Alclad metal colours!

Cuajete
Great! 👍

Roland Sachsenhofer
Thank you!
There was not much to see of the SB-17 for a short time - the application of the yellow required extensive masking!

Villiers de Vos
Very nice progress. I hope that there is no bleeding with that yellow paint 🙂

Robert Podkoński
Somehow I have missed this build... But I will follow from now!

Roland Sachsenhofer
Thank you Villiers and Robert! Indeed, I had to sand over the colour edges a little....