MiG-21MF-75
1
April 16, 2023Cockpit2
April 16, 2023Cockpit3
April 16, 2023Cockpit4
April 16, 2023Cockpit5
April 16, 2023Cockpit6
April 17, 2023Maybe not a Quickboost nozzles, but... 😉7
April 17, 2023Cowl walls a little sanded8
April 18, 2023Engine elements painted.9
April 18, 2023Fuselage ready to assembly.10
April 19, 2023Narrow ring inside exhaust casing and sharp end of cone added.11
April 19, 20230,2 mm gap cancelled by adding PCV plate at the end of wing part (end not front !)12
April 19, 2023Everything fits great now!13
April 19, 2023First layer of paint.14
April 19, 2023Wash15
April 19, 2023Imitation of tanks (oxygen and ???) added16
April 19, 2023Tanks are visible 🙂17
April 22, 2023Very little gap between parts appeared - see small, thin (0,1mm) white line. On both sides so I think it's a project's problem. Filled with Tamiya PLA Paper 🙂18
April 22, 2023Some other parts (flaps, stabilizers)19
April 22, 2023And even smaller parts with drilled holes20
April 22, 2023Small gap appeared again - this time I think it's my mistake :/21
April 22, 2023I forgot drill holes in wings before gluing halves - now it was a bit harder to drill them and do not make holes through22
April 22, 2023Fuel tank bar & canon (broken during drill holes)23
April 22, 2023Repaired cannon24
April 22, 2023Fuel tank25
April 29, 2023Catapult seat26
April 29, 2023Pylons27
April 29, 2023Base28
April 29, 2023Fuel tank painted 🙂29
May 1, 2023preshading30
May 1, 2023first layer of target colour31
May 1, 2023second layer + colors on antennas32
May 1, 2023bottom side33
May 1, 2023exhaust34
May 2, 2023Ch-23 from ResKit - base for (C)h-66, which were used in Poland.35
May 2, 2023Just to see how H-66 fits to MiG 🙂36
May 2, 2023I'm not sure should I use panel liner to highlight all rivet lines etc. It can be to "cartoon" with this livery (and preshading). Any advice?37
May 6, 2023armament frame deciphered v.002 (1/2) 😉38
May 3, 2023armament frame deciphered (2/2)39
May 4, 2023H-66 on APU-6840
May 8, 2023After a little research, it turned out that the MiG-21MF-75 in gray livery could not carry H-66 missiles. MF-75s were used only in the National Air Defense Forces. So I changed the concept again and made RS-2US and R-3S missiles41
May 12, 2023Find, cut, soak, stick, soften, remove film, mark on diagram and so on for days.... Stencils...42
May 12, 2023Find, cut, soak, stick, soften, remove film, mark on diagram and so on for days.... Stencils...43
May 13, 2023Self made decals with chosen number44
May 13, 2023Decals applied45
May 13, 2023Close-up on number46
May 13, 2023Close-up on Polish Air Force signs47
May 13, 2023Undercarriage covers painted48
May 13, 2023Undercarriage covers washed49
May 14, 2023Very subtle wash applied50
May 14, 2023Current status - I don't have the strength for the front wheel today 😉51
May 15, 2023Slow but progress 😉 Front wheel & rockets installed. The end is close (I hope).52
May 15, 2023Just second side 🙂53
May 17, 2023Almost finished and then...54
May 17, 2023... I broke decals with seals 🙁 I've to project and print a new ones55
May 18, 2023Gallery56
May 18, 2023Gallery57
May 18, 2023Gallery58
May 18, 2023Gallery59
May 18, 2023Gallery60
May 18, 2023Gallery61
May 18, 2023Gallery62
May 18, 2023Gallery63
May 18, 2023Gallery64
May 18, 2023Gallery
Kommentit
16 February 2025, 11:09 -
Album info
MiG-21MF-75 - one of 20 MiG-21MFs delivered to Poland, produced at the Gorky factory. It was painted an unusual "dove" gray - as it turned out later with radar-absorbing paint. Armament as for a pair of duty aircraft.