Audi R8 LMS GT3 (WIP)

Washed. 

Painted black surfacer for anti solar through.
Then, Painted white surfacer. 

I painted it glossy white, then masked it and painted it glossy red. 

The black part in the back is hard to masking, so I painted it with a brush. 

Applied livery decal. 

I painted over my mistakes with a brush. 

Painting... 

The Valvorine emblem is splited. 

I also painted the wheel house edge. 

I applied a clear coat, then sanded for glossy. 

Polishing done. 

1st painted other parts. 

I used tights to create a carbon effect. 

Masking and 2nd painted. 

Painted with paint bursh. (Vallejo) 

Finished applying the remaining decals. 

The tires in this kit have different sizes of inner and outer diameters. 

Ready to assemble. 

I assembled it according to the instructions manual.
Arrow : The rear suspension should not be secured yet. 

Engine room is ready. 

Cage is ready. 

Internal assembly done. 

Internal assembly done. 

Attached the parts to the inside of the bodyshell. 

The rear part is attached.
Arrows: included this part x2, but only one is used. 

I lost one of my fog light covers.
So I cut the packaging material (PET) and made a new one. 

The large windshield parts of the kit have a good surface condition, but the small clear parts do not have a smooth surface, so I sanded and polished them. 

Front parts attached. 

After combining the body with the lower body, I attached the remaining parts to complete it. 

Done.