MiG-21MF-75
1April 16, 2023Cockpit
2April 16, 2023Cockpit
3April 16, 2023Cockpit
4April 16, 2023Cockpit
5April 16, 2023Cockpit
6April 17, 2023Maybe not a Quickboost nozzles, but... 😉
7April 17, 2023Cowl walls a little sanded
8April 18, 2023Engine elements painted.
9April 18, 2023Fuselage ready to assembly.
10April 19, 2023Narrow ring inside exhaust casing and sharp end of cone added.
11April 19, 20230,2 mm gap cancelled by adding PCV plate at the end of wing part (end not front !)
12April 19, 2023Everything fits great now!
13April 19, 2023First layer of paint.
14April 19, 2023Wash
15April 19, 2023Imitation of tanks (oxygen and ???) added
16April 19, 2023Tanks are visible 🙂
17April 22, 2023Very little gap between parts appeared - see small, thin (0,1mm) white line. On both sides so I think it's a project's problem. Filled with Tamiya PLA Paper 🙂
18April 22, 2023Some other parts (flaps, stabilizers)
19April 22, 2023And even smaller parts with drilled holes
20April 22, 2023Small gap appeared again - this time I think it's my mistake :/
21April 22, 2023I forgot drill holes in wings before gluing halves - now it was a bit harder to drill them and do not make holes through
22April 22, 2023Fuel tank bar & canon (broken during drill holes)
23April 22, 2023Repaired cannon
24April 22, 2023Fuel tank
25April 29, 2023Catapult seat
26April 29, 2023Pylons
27April 29, 2023Base
28April 29, 2023Fuel tank painted 🙂
29May 1, 2023preshading
30May 1, 2023first layer of target colour
31May 1, 2023second layer + colors on antennas
32May 1, 2023bottom side
33May 1, 2023exhaust
34May 2, 2023Ch-23 from ResKit - base for (C)h-66, which were used in Poland.
35May 2, 2023Just to see how H-66 fits to MiG 🙂
36May 2, 2023I'm not sure should I use panel liner to highlight all rivet lines etc. It can be to "cartoon" with this livery (and preshading). Any advice?
37May 6, 2023armament frame deciphered v.002 (1/2) 😉
38May 3, 2023armament frame deciphered (2/2)
39May 4, 2023H-66 on APU-68
40May 8, 2023After a little research, it turned out that the MiG-21MF-75 in gray livery could not carry H-66 missiles. MF-75s were used only in the National Air Defense Forces. So I changed the concept again and made RS-2US and R-3S missiles
41May 12, 2023Find, cut, soak, stick, soften, remove film, mark on diagram and so on for days.... Stencils...
42May 12, 2023Find, cut, soak, stick, soften, remove film, mark on diagram and so on for days.... Stencils...
43May 13, 2023Self made decals with chosen number
44May 13, 2023Decals applied
45May 13, 2023Close-up on number
46May 13, 2023Close-up on Polish Air Force signs
47May 13, 2023Undercarriage covers painted
48May 13, 2023Undercarriage covers washed
49May 14, 2023Very subtle wash applied
50May 14, 2023Current status - I don't have the strength for the front wheel today 😉
51May 15, 2023Slow but progress 😉 Front wheel & rockets installed. The end is close (I hope).
52May 15, 2023Just second side 🙂
53May 17, 2023Almost finished and then...
54May 17, 2023... I broke decals with seals 🙁 I've to project and print a new ones
55May 18, 2023Gallery
56May 18, 2023Gallery
57May 18, 2023Gallery
58May 18, 2023Gallery
59May 18, 2023Gallery
60May 18, 2023Gallery
61May 18, 2023Gallery
62May 18, 2023Gallery
63May 18, 2023Gallery
64May 18, 2023Gallery
Коментари
8 November 2024, 05:30 -
Album info
MiG-21MF-75 - one of 20 MiG-21MFs delivered to Poland, produced at the Gorky factory. It was painted an unusual "dove" gray - as it turned out later with radar-absorbing paint. Armament as for a pair of duty aircraft.
